ViewSonic VPC100 - When to Use the BIOS Setup Utility; Starting BIOS Setup; Moving Around and Making Selections

ViewSonic VPC100
16
BIOSSetupUtility
WhentoUsetheBIOSSetupUtility
You need to run the BIOS Setup Utility when:
• You see an error message on the screen requesting you to run Setup.
• You want to restore the factory default settings.
• You want to modify some specific settings of the hardware.
• You want to modify some specific settings to optimize system performance.
StartingBIOSSetup
A keyboard is required to access and make selections in the BIOS Setup Utility.
Make sure the keyboard is properly installed before you power up your All-in-One
PC.
NOTE
• The Setup screens shown in this chapter are for your reference only. The actual
items or settings may slightly differ from that on your computer.
• The Setup utility may have been updated after the publication of this user guide.
• The settings you select in your operating system might override similar settings
in the Setup.
To run BIOS Setup, follow the steps below:
1. Turn on the All-in-One PC.
2. When the ViewSonic
®
logo appears, quickly press the Delete button on the
keyboard.
NOTE
If Windows operating system starts up before you press the Delete button
and you still wish to enter the BIOS Setup, restart the All-in-One PC then
follow the same procedures above.
MovingAroundandMakingSelections
The following table lists the control keys you will use to move around and select BIOS
settings.
Key Function
and Move to the previous / next item
and Move to the previous / next menu screen
+ and - Increase / decrease eld values
Tab and Shift-Tab Go to the next / previous eld