ViewSonic VPC100 - Page 37

ViewSonic VPC100
26
BIOSSetupUtility
UserPassword
To set or change the user password:
1. Select ChangeUserPassword.
2. Type the password, then press [Enter]. The password can be an
alphanumeric character of up to 6 characters in length.
3. Re-type the password to conrm, then press [Enter].
The Access level dened by the Supervisor determines the users’ setup utility
access.
PasswordCheck
When a Supervisor or User password has been set, the PasswordCheckoption
will be available in the Security Menu. With this option, you can congure when the
system will prompt you for the password:
• Setup: You are required to enter the password every time you access the
BIOS Setup Utility.
• Always: You are required to enter the password on every system boot.
ClearthePassword
• DeletingtheSupervisorPassword
1. Select ChangeSupervisorPassword.
2. When prompted to enter the new password, just press [Enter].
3. A message will appear to conrm password is uninstalled. Press [Enter].
• DeletingtheUserPassword
1. Select ClearUserPassword.
2. A message will appear to conrm clearing of password, select Ok then press
[Enter].
NOTE
Once you have set the Supervisor Password, you cannot start your computer
without entering the password. Be sure not to forget the password. Write down your
password and keep it safe and private from other people.