Viking CFDCFB5363 - Custom Grille Dimensions (Dual 30 and 36)

Note: This part should be
located at the center of the
grille. If desired, two per grille
can be used by dividing the
length of the grille into thirds.
1/2”
(1.27 cm)
1-1/2”
(3.81 cm)
1/4” Radius
(.64 cm)
2-3/4”
(6.98 cm)
1/2”
(1.27 cm)
3/4”
(1.90 cm)
3/8”
(0.38 cm)
1/2”
(1.27 cm)
R 3/32”
(0.09 cm)
3/4”
(1.90 cm)
3/4”
(1.90 cm)
3/4”
(1.90 cm)
13/32”
(1.03 cm)
9/16”
(1.43 cm)
1/8”
(.32 cm)
Grille support
2-7/8”
(7.30 cm)
1”
(2.54 cm)
1/2”
(1.27 cm)
1/8”
(.31 cm)
1/2”
(1.27 cm)
1/4” Radius
1/4” Radius
(1.2 cm)
(1.2 cm)
1/4” Radius
(.64 cm)
Reverse dimensions
for other end.
7/8”
(2.22 cm)
1/2”
(1.27 cm)
2-1/8”
(5.39 cm)
3
-1/8”
(7.94 cm)
3-5/8”
(9.20 cm)
1-3/8”
(3.49 cm)
3/8”
(.95
cm)
3/8” Radius
3/
8
” R
a
diu
s
(.95 cm)
(.
95 cm)
3/8” Radius
(.95 cm)
1/2”
(1.27 cm)
3-1/8”
(7.93 cm)
Optional hinge cover
1/2”
(1.27 cm)
3-5/8”
(9.20 cm)
3/4”
(1.90 cm)
3/4”
(1.90 cm)
3-3/4”
(9.52 cm)
3-3/4”
(9.52 cm)
3”
(7.62 cm)
3”
(7.62 cm)
3/4”
(1.90 cm)
65-1/2”
(166.37 cm)
64”
(162.56 cm)
63-15/16”
(167.48 cm)
64”
(162.56 cm)
62-3/
64”
(1
57.60 cm)
60-27/32”
(1
54.54 cm)
4-11/
64”
(11.27 cm)
5-17/
32”
(14.04 cm)
24-27/32”
(63.10 cm)
26-3/
16”
(66.51 cm)
34-11/64”
(86.80 cm)
35-25/64”
(89.90 cm)
Custom Grille Dimensions
26
Dual 30” & 36” Custom Grille
Note: Dual units can only be made
in a left and right hand configuration.
Note: To use a custom grille on a dual
installation, you must purchase the center
trim kit FCTKSS.
Note: 30” unit is on left and 36” unit is on right.
Note: Optional hinge cover can be attached using a strong VHB tape,
countersunk wood screws or short nails from a nail gun.