40
Replace unit top and four side screws.
Attach one 2 x 4 to wall stud (refer to dimensions page
for exact location).
If needed, depending on cabinet and depth,
attach second 2 x 4 to first 2 x 4.
Plug in power cord to verify operation.
Note: Make sure power switch and
showroom switch are in the “On” position.
Place unit within 3” of being flush with cabinets.
Note: To avoid cabinet damage, place cardboard
between cabinets and unit. When moving unit,
DO NOT crimp, kink or crush water supply line.
Carefully move unit until semi flush with cabinet
(depending on unit).
To Next Page
Loading...
