What to do if my Viking Refrigerator is running and no lights?
If your Viking Refrigerator is running but the lights are not working, take the unit out of Sabbath Mode. Replace the control board, light switch, or light bulb as needed.
How to fix leaky water valve in Viking Refrigerator?
To fix a leaky water valve in your Viking Refrigerator, tighten the connections or replace the water valve.
What causes insufficient water to the ice maker in Viking VCBF136?
To address insufficient water to the ice maker in your Viking Refrigerator (with correct fill time), check for any restrictions in the supply line and remove them. Also, repair or replace the water valve if necessary.
How to fix low water pressure at water valve in Viking VCBF136?
To fix low water pressure at the water valve of your Viking Refrigerator, remove any restrictions in the line.
What causes water to overflow mold in Viking VCBF136 Refrigerator?
To resolve water overflowing the mold in your Viking Refrigerator, adjust the water fill screw at the ice maker, reduce water pressure, replace the water valve, replace the ice maker, and level the ice maker or refrigerator.
What to do if water overflows fill cup in Viking VCBF136?
To address water overflowing the fill cup in your Viking Refrigerator, reposition the fill tube in the fill cup and remove any obstructions in the fill cup.
How to fix Viking VCBF136 Refrigerator that is too cold?
To fix a Viking Refrigerator that is too cold, move the control to a medium setting, ensure proper operation of the control board, and verify proper airflow.
How do I fix a clogged water valve in my Viking Refrigerator?
To resolve a clogged water valve in your Viking Refrigerator, replace the water valve.
Why is my Viking Refrigerator freezer too warm?
If the Viking Refrigerator freezer is too warm, try the following: * Move the control to a medium setting. * Check the door seal and replace it if necessary. * Clean the condenser coil. * Ensure the condenser fan is operating correctly and is free of obstructions. * Verify the operation of the control board, defrost heater and thermistor.
What to do if my Viking VCBF136 is too warm?
If your Viking Refrigerator is too warm, adjust the control to a medium setting. Check the door seal and replace if needed. Make sure airflow is not obstructed and verify the condenser/evaporator fan is working properly.
General safety guidelines and alert symbols for safe appliance operation.
Critical safety warnings including tip-over, electrical shock, and burn hazards.
Guide to operating the refrigerator and freezer controls and understanding the control panel.
Initial temperature settings and procedures for adjusting refrigerator and freezer temperatures.
Detailed steps for adjusting refrigerator and freezer temperature settings for optimal cooling.
Information on operating the ice maker, ice production rates, and storage bin.
Step-by-step guide to enter the appliance's programming mode for advanced settings.
Instructions on how to manually initiate a defrost cycle on the appliance.
Procedure to access the appliance's diagnostic service test modes.
Detailed tests for various components like defrost circuit, fans, sensors, and switches.
Procedures for testing individual components using control board test points.
Procedure to access and service the ice maker unit.
Common problems, probable causes, and suggested corrections for appliance issues.
Comprehensive wiring diagram illustrating all electrical connections within the appliance.
General| Brand | Viking |
|---|---|
| Model | VCBF136 |
| Category | Refrigerator |
| Type | French Door |
| Color | Stainless Steel |
| Finish | Stainless Steel |
| Energy Star Certified | Yes |
| Ice Maker | Yes |
| Water Dispenser | Yes |
| Defrost Type | Automatic/Frost-Free |
| Width | 35.75 inches |
| Height | 69 7/8 inches |
To Next Page
