Operation
12 ©2012 Viking Preferred Service
Door Hinge Adjustment
Removal of the upper grille assembly allows
access to door hinge for adjustment.
To remove upper grille:
1. Lift center grille louver up and pull out.
2. Using an 8” magnetic nut driver, remove
the two 1/4” screws.
3. Remove grille assembly.
4. Remove four side screws and remove unit
top. This step gives you the best access
to the hinge bolts but is not absolutely
required. You can reach in where grille
was removed with ratchet to get to hinge
bolts.
5. Loosen the four hinge bolts. Adjust door.
6. Reverse procedure for reinstallation.
To Next Page
