What to do if my Viking VCSF036SS Refrigerator still won’t operate?
If your Viking Refrigerator still won’t operate, unplug it and transfer the food to another refrigerator. If that is not available, place dry ice in the freezer section to preserve the food. Note that the warranty does not cover food loss.
Why does ice form in the inlet tube to the ice maker in my Viking VCSF036SS Refrigerator?
If ice forms in the inlet tube to the ice maker of your Viking Refrigerator, check the water pressure to ensure it meets requirements. Open the saddle valve completely. Adjust the freezer temperature.
Why does the water from my Viking Refrigerator appear cloudy?
If the water from your Viking Refrigerator appears cloudy, it is likely due to air or air bubbles in the water. This is normal when first using the dispenser and will disappear with use.
Why is the water filter indicator light red on my Viking VCSF036SS?
If the water filter indicator light is red on your Viking Refrigerator, replace the water filter. You may also need to reset the filter indicator sensor.
General| Brand | Viking |
|---|---|
| Model | VCSF036SS |
| Category | Refrigerator |
| Type | French Door |
| Total Capacity | 36 cu. ft. |
| Width | 36 in. |
| Finish | Stainless Steel |
| Ice Maker | Yes |
| Water Dispenser | Yes |
| Energy Star Certified | Yes |
| Water Dispenser Type | Internal |
| Door Style | French Door |
Explains DANGER, WARNING, CAUTION levels used in safety messages.
Warns against repairs by unqualified individuals to avoid injury or death.
Viking's disclaimer regarding injury or damage from improper service procedures.
Contact information for locating an authorized Viking servicer.
Covers defects in material or workmanship for two years from original retail purchase.
Warrants sealed refrigeration system components for years three through six.
Covers sealed system parts for years seven through twelve, labor extra.
Applies to extended residential use applications like B&Bs, excluding commercial.
Details on obtaining warranty service, including contact and required information.
Explains the electronic defrost system and the location of the serial number.
Covers location requirements, opening measurements, and clearance for installation.
Instructions for leveling the refrigerator and adjusting door alignment.
How to adjust and set refrigerator and freezer temperatures using the control panel.
Explains the functions of Max Ice and Vacation Mode features.
Details on the Water Filter Indicator and Door Open Alarm functions.
Explains the operation and activation of High Temp Alarm and Max Cold.
Adjusting temperature display, alarms, auto light, and Sabbath mode.
Explanation of warm cabinet surfaces as a normal operating condition.
Describes the dispenser control panel buttons and their basic functions.
Covers Dispenser Lock, Auto Light, and Sabbath Mode activation.
How to use the dispenser pad and information on the removable tray.
Warnings and cautions to follow before cleaning the appliance.
Guide for recommended cleaning products and methods for different parts.
Lists normal operational sounds and their possible causes.
Addresses issues like unit not operating, temperature too warm/cold, and odors.
Troubleshooting for water droplets and doors not closing properly.
Resolves issues with dispenser lights and unfamiliar operational sounds.
Addresses problems with the unit running too frequently.
Issues with ice/water dispensing and ice maker performance.
Troubleshooting slow water flow, filter indicator, and cloudy water.
Problems with ice formation, water temperature, and ice/water particles.
Addresses leaks, unit not running, and sections being too warm.
Diagnosing issues with refrigerator/freezer temperature and evaporator frost.
Troubleshooting frequent unit cycling and airflow problems.
Addresses freezer too cold and continuous unit operation.
Identifies causes and solutions for noisy refrigerator operation.
Resolves problems with dispenser LEDs and lights not activating correctly.
Troubleshooting water not dispensing when activated.
Addresses incorrect dispensing activation and illumination errors.
Troubleshooting dispenser operating continuously, including lock mode issues.
Diagnosing problems with the Auto Light feature and filter status indicator.
Troubleshooting auger motor operation and ice chute door issues.
Diagnosing issues when dispenser mode selection does not function correctly.
Troubleshooting when the dispenser cavity becomes frosted or iced.
Explains minimum pressure for proper water dispensing speed.
Covers entering programming mode and setting default configurations.
Instructions for forced defrost and entering service test mode.
Procedures for testing defrost, fans, compressor, thermistors, and doors.
Procedures for testing dispenser components like lights and actuators.
Testing keypad operation, LED indicators, and ice maker valve.
Procedures for setting Fahrenheit/Celsius, Show Room, Sabbath, and Alarm modes.
Methods for testing capacitor resistance and continuity.
Procedures for testing compressor winding resistance and ground faults.
Performing an operational test on the compressor by direct wiring.
Methods for testing the condenser and detecting leaks.
Procedures for testing the overload relay resistance.
Testing condenser motor, evaporator fan motor, and water valve.
Testing light switches and the defrost timer.
References for control board and ice maker service.
Instructions for replacing the drier filter and handling desiccants.
Testing the defrost heater and thermostat for proper function.
Procedures for testing the evaporator and thermistor resistance.
Testing the electric damper control for resistance.
Analyzing suction, head, and temperature variations from normal.
Identifying symptoms of refrigerant overcharge and air in the system.
Recognizing signs of a refrigerant shortage in the system.
Explains how ambient temperature and heat load affect system performance.
Identifying and diagnosing restrictions within the refrigeration system.
Lists the necessary tools and equipment for HFC134a system servicing.
Procedures for testing sealed systems for refrigerant leaks.
Precautions for handling refrigerants and accessing system lines.
Performing direct wire tests on the compressor for operational checks.
Steps to remove moisture from the sealed refrigeration system.
Methods to diagnose restrictions in capillary tubes or drier filters.
Diagram and setup for evacuation and charging equipment.
Detailed steps for evacuating the sealed refrigeration system.
Step-by-step guide for charging the refrigeration system with refrigerant.
Information on HFC134a properties, health, safety, and handling.
Compares properties of CFC12 and HFC134a refrigerants.
Guidelines and materials for brazing refrigeration system components.
Procedures for removing and installing a replacement service compressor.
Steps for safely replacing the drier filter in the system.
Illustrates the path of refrigerant through the system components.
Diagram showing airflow paths within the refrigerator cabinet.
Diagram showing the location of water and ice dispenser components.
Steps for removing light bulbs, switches, and covers.
Procedures for removing the electronic control assembly and board.
Steps for removing the electronically controlled damper and refrigerator thermistor.
Instructions for removing the crisper section light socket.
Procedures for removing and replacing the water filter assembly.
Steps to access the machine compartment for servicing.
Steps for removing the water tank assembly.
Procedures for removing the water valve assembly.
Steps for removing freezer section light bulbs and sockets.
Procedures for removing the auger motor assembly and capacitor.
Steps for removing the auger motor and evaporator fan motor assembly.
Instructions for removing the defrost thermostat.
Procedures for removing the defrost heater and evaporator coil.
Steps for removing the ice maker unit.
Procedures for removing the freezer thermistor and condensate drain tube.
Steps for removing the compressor, overload, and relay components.
Procedures for removing the condenser fan motor/blade and the condenser coil.
Instructions for removing the condensate drip pan.
Steps for removing leveling rollers, door gaskets, and dispenser façade.
Procedures for removing dispenser light bulbs and sockets.
Steps for removing the dispenser pad, switch, and control board.
Procedures for removing the ice chute door, solenoid, and related parts.
Steps for removing the water tube from the dispenser.
Procedures for removing the refrigerator doors and hinges.
Steps for removing the refrigerator door handles.
Instructions for installing refrigerator door handles.
To Next Page
