20
7.10 Standby brightness level setting
The menu lets you set the brightness level when the thermostat is in standby mode.
Via and select one of the following levels with gradually increasing brightness:
•
•
•
•
•
•
•
While scrolling through the values, when the selection stops on a certain level, the brightness of the
display will, for approximately 2 s, take on the brightness corresponding to the selected level in order to
allow the user to check the visual effect.
Lastly, tap to confirm your choice.
7.11 Info
This menu lets you view information related to the thermostat and reset the device.
Via and you can select:
• : displays the number of hours that the thermostat relay has been on (the same as the number of
hours of operation of the heating/air-conditioning system).
The counter can be reset, for example at changes in season to differentiate between heating and
air-conditioning.
• : displays the software version of the device.
• : returns the device to the factory default values resetting all the settings made (temperature,
colours, etc.).
7.12 Lock/unlock PIN setting
This menu lets you add/change the password to inhibit use of the thermostat.
Using and set the three digits of the PIN one at a time and then confirm each set digit
with .
If you wish to have free access to the thermostat (so without it prompting you for a password) it is suf-
ficient to set the PIN to "000".
To reset your PIN, if you forget the value you entered, proceed as follows:
1. Cut off power to the thermostat
2. Power up the thermostat again
3. Within the first 30 s, i.e. before going into Standby mode, go to the PIN menu and enter the new
value.
To Next Page
Loading...
Need help?
General
