40
Settings
NOTICE: It is not possible to stop the touch calibration function. Once started it must be completed.
To exit the menu touch Exit.
2.4 Favourite Application.
Used to set the start-up screen you want to be displayed.
Main Menu
Setup
Settings
Favourite Application
Scroll with upwards or downwards through the menu items and select the desired application; confirm
lastly by touching Save.
The control panel confirms the operation has been completed.
2.5 Screen saver.
Used to set the time of inactivity at the end of which the control panel activates the screen saver and cuts off the
display backlighting.
Main Menu
Setup
Settings
Screensaver
-Touching Off disables the screen saver.
-Touching Delay enables setting the inactivity time at the end of which the control panel activates the screen
saver.
With upwards or downwards select the desired value then touch Set; the control panel confirms
the operation carried out.
The activation time of the screen saver set by default is equal to 1 and a half minutes.
NB: If the screen saver is disabled, after 1 and a half minutes only the display backlighting is cut off.
2.6 Temperature Probe
Once the installer has correctly configured, connected and enabled the probe, it is possible to view the measured
temperature.
Main Menu
Temperature Probe
The display will show a screen that shows and periodically updates the current temperature measured by the
sensor. The temperature value is given in the unit of measurement configured on the device (see the following
paragraph 2.7).
Touching Menu takes you back to view the main menu of the control panel.
2.7 Temperature Unit
Used to select the temperature unit from degrees Celsius or degrees Fahrenheit.
Main Menu
Setup
Settings
Temperature Unit
To Next Page
Loading...
Need help?
General
