Vimar ELVOX K40980 - Configuring Administration Keys; Adding User Keys; Removing User Keys

22
K40980 - K40981
EN
Conguringtheadministrationkeys
1) Withthefrontnotinstalled,quicklypresstheresetbuttonontheoutdoorstationtwice:thedevicewillrespondwitha
sequenceof4beeps.Thecongurationprocedurebeginsfromthismomentandissignalledbytheslowashingofthe
nameplatebacklightingLEDs;anypreviouscongurationsaredeleted.Alternatively,youcanlaunchtheconguration
procedurefromtheadministrationmenuofanindoorstation,see"Installersettings":inthiscase,anypreviouskey
conguration(administratoranduser)willnotbedeleteduntilyouproceedtothenextstep2.Inthiscasetoo,thekey
programmingstatusissignalledbytheslowashingofthebacklightingLEDs,anditlastsabout30s.
2) BringtherstkeyuptotheRFIDreader;thedevicewillemitalongbeep;therstkeyisconguredas“administrationkey
foraddition”.
 Werecommendmarkingthekeywith“keyforaddition”
3) BringthesecondkeyuptotheRFIDreader;thedevicewillemitalongbeep;thesecondkeyisconguredas“administration
keyforremoval”.
Werecommendmarkingthekeywith“keyforremoval”.
Theadministrationkeysandalluserkeyscanberesetbyrepeatingtheaboveprocedurefromthebeginning.
4) Ifnootheractioniscarriedout,theregistrationprocedurewillendafter30secondswithawarningtone(4beeps).
Anynewcongurationoftheadministratorkeysanduserkeyswillbepossible,repeatingtheaboveprocedurefromthebeginning.
Thefrontcasecannowbeinstalledontheoutdoorstation,takingcaretoclosetheanti-tamperkey.
Adding a user key
Fortheadditionandremovalofuserkeys,thefrontoftheoutdoorstationdoesnotnecessarilyhavetobeopened.These
operationscanalsobecarriedoutaftertherst-timesysteminstallation.
1) Bringthe“administrationkeyforaddition”uptotheRFIDreader:thedevicewillbeepandstarttoashslowly.
2) Bringanunprogrammedkeyuptothereader.Thedevicewillenableitasa“userkey”.Thedevicewillbeepwhenthe
congurationiscomplete.
3) Repeatstep2)toaddanyotherkeys.
4) Theprocedureforenablinguserkeyswillterminateafterabout5sofinactivity.
Thedevicewillbeep4timesandstopashingtoindicatetheendoftheprocedure.
Thekeysaddedusingthisprocedurewillimmediatelybeavailablefortheactivationoflocks,asspeciedbelow.
Removing user keys
Auserkeycanonlyberemovedusingtheactualkeyitself,asspeciedbelow.
1) Bringthe“administrationkeyforremoval”uptotheRFIDreader;thedevicewillbeep.
2) Bringauserkeyuptothereader.Thedevicewilldisableit.Thedevicewillbeepwhenthecongurationiscomplete.
3) Repeatstep2)toremoveanyotherkeys.
4) Theprocedurefordisablinguserkeyswillterminateafterabout5sofinactivity.
Thedevicewillbeep4timestoindicatetheendoftheprocedure.