Vimar ELVOX SW24.W - Page 10

8
SW24.W
EN
LRNT LRNA
Advanced travel calibration.
The calibration allows the installer to choose:
- Slowdown position in opening and closing
- O󰀨set for opening and closing
- Pedestrian opening position
Pressing
button
Msg on
display
Phase description
- PP Wait for start of calibration procedure
PP CL 2 When button pressed: motor 2 starts closing and searches for closing
stop
- CL 1 Motor 1 starts closing and searches for closing stop
PP OP 1 Start opening motor 1
When button pressed: slowdown start position on opening setting.
PP OP 1 Continuation of motor 1 opening at slowing speed.
When button pressed: end of travel position setting.
No button pressed: continuation to the stop.
PP OP 2 Start opening motor 2
When button pressed: slowdown start position on opening setting.
PP OP 2 Continuation of motor 2 opening at slowing speed.
When button pressed: end of travel position setting.
No button pressed: continuation to the stop.
PP CL 2 Start closing motor 2
When button pressed: slowdown start position on closing setting.
- CL 2 Continuation of motor 2 closing at slowdown speed up to stop.
PP CL 1 Start closing motor 1
When button pressed: slowdown start position on closing setting.
- CL 1 Continuation of motor 1 closing at slowdown speed up to stop.
OPED Start pedestrian opening.
When button pressed: pedestrian opening position setting
- CPED Leaf closing from pedestrian opening position
PP DLOP Start opening.
When the o󰀨set time setting in opening button is pressed, motor 2
starts.
PP DLCL Start closing.
When the o󰀨set time setting in closing button is pressed, motor 1 starts.
- END End of procedure
Self-calibration
If the gate travel parameter is changed, there is no need for the installer to run new calibrations, however, when chang-
ing the travel parameters, the control panel needs to learn the current curve again, thus disabling the obstacle detection
only during the self-calibration manoeuvre.
Self-calibration is appropriately signalled:
- on the control panel display by the code AT
- by the light ashing at twice the normal frequency
The events generating self-calibration are:
- change in parameters: T24, T25 ,T26, T27, T28, T29, T30, T31, T32, T33, T34, T35, T40, T41.
- loading of settings from a MEM.W memory card
- reset/import of settings from the By-gate Pro