Vimar ELVOX SW24.W - Page 11

9
SW24.W
EN
TRV
Gate travel parameters
T1
Power of motor 1 (%)
Sets the value of the force given to motor 1 to push the leaf
Default
50
1 Minimum force
100 Maximum force
T2
Power of motor 2 (%)
Sets the value of the force given to motor 2 to push the leaf
Default
50
1 Minimum force
100 Maximum force
T3
First leaf to move
Default
M1
M1 Motor 1
M2 Motor 2
T4
Direction.
Sets the motor direction
Default
1
1 Standard (for a linear actuator, leaf closed with rod extended)
2 Inverse (for a linear actuator, leaf closed with rod retracted)
Note:
Inverts both motors. If only one motor has an incorrect direction, invert the power supply wires on the
motor with the incorrect direction.
T6
Number of motors
Default
2
1 Single-leaf gate
2 2 leaf gate
T7
Choice of intervention method for obstacle detection
Default
1
1
Overcurrent or leaf stopped: the obstacle is detected when the current threshold or the
encoder slowdown threshold is exceeded
2 Leaf stopped: the obstacle is detected only when the leaf slows down excessively
3 Overcurrent: the obstacle is detected when the current threshold is exceeded
4
Overcurrent and leaf stopped: the obstacle is detected when the current threshold and
the encoder slowdown threshold are exceeded at the same time
T10
Obstacle detection time motor 1
Time after which the current threshold or the encoder threshold trigger the obstacle detection
on opening (adjustable at intervals of 100 ms)
Default
20
10 100 ms (minimum time)
60 600 ms (maximum time)
T11
Obstacle detection time motor 2
Time after which the current threshold or the encoder threshold trigger the obstacle detection
on opening (adjustable at intervals of 100 ms)
Default
20
10 100 ms (minimum time)
60 600 ms (maximum time)
T12
Polling time
Time during which the motor pushes with maximum force to move the leaf (adjustable at
intervals of 0.5 s)
Default
2.0
0.5 0.5 s (minimum time)
5.0 5.0 s (maximum time)
T13
Pedestrian opening position
(% of total opening travel of rst leaf)
Default
2.0
10 Minimum space
100 Maximum space
T14
Disengagement space on obstacle
(inversion distance following the detection of an obstacle)
Default
50
OFF Not disengaged, stops only
1 Minimum inversion
10 Maximum inversion