32
Vincent
SEARCH FOR ERRORS
Symptom Possible Cause Countermeasure
Unit does not work
after pressing the
power button
M
ains cable is not connected to a suitable
m
ains wall outlet.
Mains cable has not been firmly inserted into
wall power socket and the device’s socket.
O
therwise it may be defective.
Unit fuse or unit is defective.
C
onnect to a functioning socket using a suit-
a
ble mains voltage.
Check the power cable. If necessary,
exchange it with a suitable mains cable and
p
ush its plug firmly into wall socket and the
d
evice's power connector.
Contact your dealer.
No sound on both
channels although the
unit is ready for use
(LED (3) is lit)
The audio source currently selected at the pream-
plifier is giving no signal.
The output of the source device is not connected or
is wrongly connected e.g. not connected to the
selected input channel terminal of the preamplifier.
Wrong input channel has been selected at the pre-
amplifier.
Volume setting of the preamplifier is set too low.
The preamplifier has been muted (MUTE-Function).
Output of the preamplifier not connected or incorrect-
ly connected to the input connectors of the SP-332.
The setting of the toggle switch “XLR/RCA” (10) on
the front panel is not correct.
The speaker cable is not properly connected to the
main amplifier's terminals (5) or is defective.
Switch on the source unit and begin play-
back.
Correct the connection.
Set the preamplifier to the input that your
desired source is connected to.
Carefully increase the volume of the preampli-
fier.
Deactivate the MUTE function at the preampli-
fier after, as a precaution, reducing the volu-
me level.
Correct the connection to the preamplifier.
Reduce the volume setting of the preamplifier
and set the selector to the correct input.
Check and tighten the speaker cables at the
main amplifier (5) and at the speakers.
No audio playback
on one channel
The source equipment is giving signal on only
one channel.
One of the signal cables between audio sour-
ce and preamplifier inputs has not yet been
plugged in or is defective.
The channel balance is in a wrong setting at
the preamplifier.
One of the loudspeaker cables or one of the
signal cables between pre and main amplifier
is not correctly connected or it is faulty.
Check the audio source. You can try to use it
at a different amplifier for a test.
Check the cable connections, tighten them if
necessary.
Set the difference in channel volume
(“BALANCE” or “CHANNEL”) of the pream-
plifier to the desired setting.
Check all the connections of the main amplifiers
and whether the loudspeakers are working.
To Next Page
Loading...
