Use the screw set (screw & anchor) to mount the new
wall plate. In most cases, the old mounting position can
be used; if not, apply the new set. Be sure to check the
alignment of the new wall plate before and after the wall
plate installation.
Disconnect the wires from the old thermostat one by
one, you may need a screwdriver to release wires from
terminals.
NOTE : Wrap the wires around a pen or pencil so they
don’t fall back into the hole in the wall.
Step 6
Disconnect the wires and remove the old wall plate
Mount the New Wall Plate
Step 7
Compatibility
Checker
08
To Next Page
Loading...
