User’s Manual
Terminal default remote TCP/UDP server port (Automode)
Port that ESERV-10 makes connection to server in Automode.
Terminal default remote IP address (Automode)
Server IP address that ESERV-10 makes connection in Automode.
TCP connection hangtime (secs)
If traffic stops in TCP connection, idle time after which the connection is closed by ESERV-10.
5. E-mail settings
Incoming (POP3) server
Server for incoming mail where ESERV-10 reads emails using POP3 protocol.
Outgoing (MAIL) server
SMTP server address what ESERV-10 uses for sending email.
My E-mail address
Email address for from field in outgoing emails.
User name
User name for POP3 server.
Password
Password for POP3 server.
Mail check interval (secs, 0=never)
Interval for polling POP3 server.
Subject to outgoing mails
Subject for outgoing emails send via SMTP server.
Max. incoming E-mail len (0=no limit)
Limit for incoming emails that ESERV-10 is allowed to receive.
Send E-mail sender addr & subj. to RS?
Selects if only body of message goes to serial port or the whole email.
Default recipient E-mail address
Recipients email address where ESERV-10 sends email.
Action to incoming E-mail in AT mode INDICATION
Action to incoming new E-mail on AT command mode:
INDICATION only (outputs +CMTI:SM,<index>
DIRECT READ directly (outputs +CMT:<oa>,<scts><CR><LF><subject><CR><LF><data>)
6. AT commands settings
Indicate ESERV start-up ON
Indicates on ESERV-10 startup on AT command mode by outputting ^SYSSTART.
ESERV-10 38 Viola Systems Ltd.
To Next Page
Loading...