VIOMI Alpha 3 - Page 13

10
Installation
1. According to the figure, insert the mop along the slot of the vibrating
mop support and stick it on the hook & loop.
2. Take out the freshwater tank and add municipal tap water below the
maximum water level.
Tip: Please check the dirtywater tank regularly. If there is dirtywater, please dump it in
time to ensure that there is no water in the dirtywater tank.
Mopping mode (installation of fresh water tank and dirty
water tank and mop):
Mop
Maximum water level
Hook & loop
3. Install the freshwater tank and dirtywater tank into the cleaning station,
and fasten the cover of the cleaning station aer completion.
Notices:
In order to ensure the sterilization effect of brine electrolysis, please add municipal
tap water into the fresh water tank and do not use purified water.
Do not inject hot water into the fresh water tank to avoid deformation of the fresh
water tank.
Do not inject hot water into the dirty water tank to avoid deformation of the dirty
water tank.
When mopping the floor, please set up virtual walls or forbidden zones in the carpet
area.
It is forbidden to use cleaning products such as detergent, disinfectant and solid
detergent to avoid corrosion and damage to the equipment.
In case of water accumulation, please clean up the accumulated water before using
the function of cleaning or mopping.
Aer mopping the floor, please take out and clean the dirty water in time, and clean
the cleaning brush, cleaning slot and sewage mesh to avoid odor and mildew