Manual VIPA System 200V About this manual
HB97E - IM - RE_253-xDPxx - Rev. 12/44 1
About this manual
This manual describes the System 200V PROFIBUS DP slave modules
IM 253-xDPxx from VIPA. Here you may find every information for
commissioning and operation.
Chapter 1: Basics and Assembly
The focus of this chapter is on the introduction of the VIPA System 200V.
Here you will find the information required to assemble and wire a
controller system consisting of System 200V components.
Besides the dimensions the general technical data of System 200V will be
found.
Chapter 2: Hardware description
Here the hardware components of the IM 253-xDPxx are described.
The technical data are at the end of the chapter.
Chapter 3: Deployment IM 253DP
This chapter contains a description of the PROFIBUS DP slave modules IM
253-xDPxx under PROFIBUS. A short introduction and presentation of the
system is followed by the project design and configuration of the
PROFIBUS slave modules that are available from VIPA.
The chapter concludes with a number of communication examples and the
technical data.
Overview
To Next Page
Loading...
