10
© 2012 Directed. All rights reserved.
Programming your 2-way remote control
To enter programming mode:
Press and hold the
P
button located on the back of the remote con-
trol until one long beep sounds. You can now customize the remote’s
response feedback. If no buttons are pressed within 5 seconds, pro-
gramming mode is exited; the remote sounds 2 beeps.
Beeps and Vibration, On/Off
Press to select beep/vibration On or Off, or one of the below
settings.
Beeps/Vibrate Response Icon*
Beeps only
1 beep
Vibrate only
1 vibrate
Beep & Vibrate
1 beep & 1 vibrate
&
No Beep & No
Vibrate
1 long beep
*Displays during programming
Illumination On/Off
Press to select LCD backlight illumination On/Off. The LCD back-
light will illuminate when a remote button is pressed, or an alarm status
page is received.
LCD backlight settings Programming
On
1 beep backlight On
Off
2 beeps backlight Off
To Next Page
Loading...
