Viper 3305V - System Maintenance

36
© 2012 Directed. All rights reserved.
System maintenance
This system needs no specific maintenance beyond remote control
battery replacement. The 2-way remote is powered by one 1.5V AAA
battery. The 1-way remote is powered by two 3V, CR2016 batteries.
Battery Level Indicator, 2-way
The Battery Level indicator has four level indicators that serve as a
visual indication of battery charge. When the battery reaches a low
charge level that requires replacement, the remote control generates
a single notification chirp, and the Battery Level indicator flashes con-
tinuously.
FULL
REPLACE
EMPTY
Battery replacement, 2-way
1. Gently pull the end of the battery door away from the top of the
remote control then slide the door up to expose the battery.
2. Replace the expired battery with a new battery, observing the
correct polarity.
3. Reinstall door and close to latch. When power is returned, the
remote control plays a melody and all icons in the LCD are
displayed. Press any button on the remote to stop the melody.
1 -way remote
1. Using a small flat-head screwdriver, insert into slot located on the
side of the remote control and carefully pry open the unit.
2. Turn unit over and carefully remove rear housing. Remove the
battery from holder and replace with a new one.
3. Reassemble all parts and snap together.
Note
Verify that the battery polarity is correct when replacing.