Viper 3305V - VRS Disarming Methods; Disarming Before Trigger Sequence; Disarming During Trigger Sequence

27
© 2012 Directed. All rights reserved.
If the system has not entered the triggered sequence (siren has not
started chirping):
1. Turn the ignition on.
2. Press
button on the remote control. The lights flash and the
siren chips. If the system has entered the triggered sequence (si-
ren has begun chirping), pressing the disarm button of the trans-
mit ter will not disarm VRS.
To disarm the VRS during a VRS trigger sequence:
1. Turn the ignition on.
2. Press the Valet button the pre-programmed number of times to
disarm the VRS system.
If the VRS has begun its chirping sequence, the ignition must be
turned off, then On, to disarm. If you are driving the vehicle, pull
over to a safe place and follow the triggered sequence disarm
procedure.