Viper 330V - Door Lock Learn Routine Steps; Learn Lock Polarity Procedure; Learn Unlock Polarity Procedure

24
© 2005 directed electronics, inc.
to learn lock:
NNOOTTEE::
Make sure the doors, hood and trunk are closed so the factory RKE system oper-
ates as it would when the user is using it.
11.. WWiitthh aallll tthhee ddoooorrss,, hhoooodd aanndd ttrruunnkk cclloosseedd::
Press and HOLD the Valet
®
button.
22.. WWiitthhiinn 55--sseeccoonnddss::
Turn the ignition On and then Off (leave for less than 2-seconds
in the on position).
33.. WWiitthhiinn 55--sseeccoonnddss::
Release the Valet
®
button.
44.. WWiitthhiinn 55--sseeccoonnddss::
Press and release the Valet
®
button once.
55.. WWiitthhiinn 55--sseeccoonnddss::
Press and HOLD the Valet
®
button. The LED will flash to indicate
that the lock routine is ready to be learned.
66.. PPrreessss lloocckk bbuuttttoonn::
Press the lock button on the factory transmitter. Wait for the LED
to illuminate to indicate the the lock learn was successful. If the learn was unsuccess-
ful the LED would continue to flash.
77.. RReelleeaassee tthhee VVaalleett
®®
bbuuttttoonn..
Now advance to the learn Unlock routine.
to learn unlock:
11.. WWiitthhiinn 55--sseeccoonnddss
of the learn lock routine (step 7), press and release the Valet
®
but-
ton once.
22.. WWiitthhiinn 55--sseeccoonnddss::
Press and HOLD the Valet
®
button. The LED will flash in groups
of two flashes to indicate that the unlock routine is ready to be learned.
33.. PPrreessss uunnlloocckk bbuuttttoonn::
Press the unlock button on the factory transmitter. The LED will
illuminate for a maximum of 5-seconds to indicate that the unlock learn was success-
ful. If the learn was unsuccessful the LED would continue to flash in groups of two.
44.. RReelleeaassee tthhee VVaalleett
®®
bbuuttttoonn..