INSTRUCTION FOR USE ENGLISH
10
OPERATING HINTS
1) Use cool water only. Hot water may set a stain.
2) Continually check for foam buildup in recovery tank. Use a distributor recommended foam control solu-
tion.
NOTE: Excessive foam buildup will cause damage to the vacuum motor.
3) Repeat extraction path on heavily soiled areas.
4) When recovery of the dirty solution ends, or the solution tank is empty, you must drain the recovery tank. (see
TANK DRAINING)
DRAINING TANKS
DRAINING SOLUTION TANK
1) Turn machine off and unplug from power source.
2) Disconnect solution and vacuum hoses from front of machine.
3) Unhook clamps on recovery tank and remove recovery tank from machine.
4) Carry solution tank to an approved drain and dump out contents.
DRAINING RECOVERY TANK
1) Turn off machine and unplug from power source.
2) Unhook clamps on recovery tank and remove recovery tank from machine.
3) Carry recovery tank to an approved drain and dump out contents.
4) Rinse recovery tank with clean water.
5) Assembled the machine again.
MAINTENANCE
To keep the machine performing well for many years, please follow the following maintenance procedures.
!!! Always confirm that the machine is unplugged prior to performing any maintenance or
repairs!!!
DAILY MAINTENANCE
To Next Page
Loading...
