About sleeve cleaning:
Minerals in the water slowly form a coating on the sleeve. This coating must be removed because it
reduces the amount of UV light reaching the water, thereby reducing disinfection performance.
About lamp replacement:
The amount of UV light created by the lamp decreases over time, requiring that the lamp be
replaced. The system will automatically notify you when it is time to replace the lamp (the lamp
should last approximately 24 months).
Equipment required:
Cloth must be
soft, lint-free, and
chemical-free. No
clean-wipes.
Scale remover
such as CLR
TM
or
Lime-Away
TM
.
#2 Phillips
screw driver
Cotton swab.
Clean cotton,
latex or plastic
gloves are
preferred.
Part Lamp Sleeve Length
UVMAX G & Pro10 602854 602974 15.1“
UVMAX H & Pro20 602855 602975 26.7“
UVMAX J, K & Pro30, Pro50 602856 602976 36.5“
To Next Page
Loading...
