virtual access GW1000M Series - 3 Getting Started

_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
© Virtual Access 2021 Confidential Page 9 of 23
3 Getting started
3.1 GW1000M Series components
To enable and configure connections on your router, it must be correctly installed.
The routers contain an internal web server that you use for configurations. Before you
can access the internal web server and start the configuration, ensure the components
are correctly connected and that your PC has the correct networking setup.
3.1.1 Standard components
1 x GW1000M Series router
1 x plastic carrier
1 x lockable SIM cover
Table 1: GW1000M Series router standard components
3.1.2 Optional components
Ethernet cable. RJ45
connector at both ends.
Power supply unit.
Right angle antenna for
3G or 4G network.
Virtual Access supplies a wide range of antennas for
3G or 4G networks. Please visit our website:
www.virtualaccess.com or contact Virtual Access for
more information.
Right angle or straight
stubby antenna for WiFi
connection
Virtual Access supplies a wide range of antennas for WiFi. Please
visit our website: www.virtualaccess.com or contact Virtual
Access for more information.
1 x automotive cable
Fused automotive cable
Non-fused automotive cable
Table 2: GW1000M Series router optional components