_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
© Virtual Access 2021 Confidential Page 22 of 23
5.1.6 Verify the firmware has been upgraded successfully
To check the firmware version, in the top menu, browse to System -> Flash
Operations, or after router reboots, in the top menu, click Status. The Firmware
Version shows in the system list and also in the right top corner of the menu bar.
Figure 24: The system status list showing current firmware version
5.2 Firmware recovery
The router has an automatic boot recovery feature that will
• revert the active firmware to the alternate firmware segment on three
consecutive failed software restarts.
• Change the boot configuration to factory configuration after ten failed restarts
By design this feature is intended to allow recovery from firmware problems and
therefore excludes restarts due to power loss.
To Next Page
Loading...