9
Viscount Chorum
User Manual
1. PEDAL section.
Contains pedal stops and manual-pedal couplers. The couplers available are:
- [I/P]: Man.I to Pedal.
- [II/P]: Man.II to Pedal
- [III/P] (only three-manual models): Man.III to Pedal
2. MAN. II. section.
Contains stops, couplers and tremulant of Manual II.
In the three-manual models the couplers available are:
- [III/II]: Man.III to Man.II
- [I/II]: Man.I to Man.II
3. MAN.III section.
Contains stops and tremulant of Manual III.
4. MAN.I section.
Stops, manual couplers and tremulants for Manual I. The couplers available are:
- [III/I] (three-manual models): Man.III to Man.I
- [II/I] (two-manual models): Man.II to Man.I
5. Sezione ORCHESTRA.
Contains the orchestral voices. It is possible to select the voice activated by each stops. For further
information read par. 8.4.
With models that do not have this section, it is necessary to activate the orchestra voices using the
functions described in par. 6.2. A document with the list of stops that can be assigned to orchestra voices
can be downloaded from the website www.viscountinstruments.com. The document contains the list for
each model of the series.
6. Power switch.
Instrument on/off switch.
7. General combinations.
- [1] / [6]: pistons to recall the combinations saved in the selected memory bank (see [PREV] /
[NEXT] point). These combinations can be modified. To do so, follow the procedure described at
point 13.
- [HR]: restores the voice setup prepared in manual mode before a memory was recalled.
- [PREV.] / [NEXT]: general combinations sequencers. [PREV.] displays them in descending order,
[NEXT] in ascending order. Keeping pressed the [S] thumb piston and acting these commands it
is also possible to select the memory bank.
8. Pedal pistons.
- [1] / [6]: pedal divisional combinations. These combinations can be modified. To do so, follow the
procedure described at point 13.
- [HR]: restores the voice setup prepared in manual mode before a memory was recalled, when the
piston is on.
9. Manual III pistons.
- [1] / [6]: Man. III divisional combinations. These combinations can be modified. To do so, follow
the procedure described at point 13.
- [HR]: restores the voice setup prepared in manual mode before a Man.III memory was recalled,
when the piston itself is on.
- [P]: Man. III to Pedal coupling.
To Next Page
Loading...
