Vishay VT 200 - Connecting PCB and Setting Jumper

Outputs and Digital Input
Configuring Analog Output
VT200/220 Technical Manual, Rev 1.00.01 67 Doc # TM-VT200/220-EN
7.4.1 Connecting PCB and Setting Jumper
In order to use analog output, the option PCB (PCB 761) connected it to the VT200 as
follows: In the one side to ST5 socket on the main board and in the other side using
the mounting posts/spacers provided to:
Stainless steel enclosure – Main board.
Aluminum enclosure – Indicator’s rear panel (see page 80).
Jumper JP1 determines the output mode – current or voltage.
Analog output pins connections:
1. Connect pins as follows:
 For current output, connect pin 1 (current output, +) and pin 3 (common).
 For voltage output, connect pin 2 (voltage output, +) and pin 3 (common).
2. Connect an external power supply of 24VDC, using pins 4 and 5:
 Pin 4 – power in (+).
 Pin 5 – power in (-).