Vision Tech DLP-300 - Power Sockets and Requirements

11
1.5 Power sockets and requirements
1
）
Power outlet
：
AC 187V~242V
50Hz 1.5A
Power: Max 90W
Hole 3 Ground wire
2
）
Claim
：
（
1
）
On electrical circuits, no high-noise devices (such as compressors, motors,
etc.) can run on them.
（
2
）
Make sure that the power socket is wired correctly. If you are not sure about
the working status of the power outlet, please contact an electrician for
certification.
（
3
）
You can only plug the power cord of the scale into the power socket after
confirming the safety of the electrical wiring.
（
4
）
The third hole is a safety ground wire, and the electrician should wire it
correctly. If not correct, any electronic scale may cause electric shock.
（
5
）
Do not use any 3-hole to 2-hole terminal block, or the third hole that has
been disconnected after the power cord is connected. The third hole is required
and must be connected correctly.
（
6
）
If you have any questions or problems, please be sure to contact the
service department of SHANGHAI DIGITAL BALANCE ELECTRONIC CO., LTD.