Vision REVO - 9 System installation; 9.1 Unpacking and inspection; 9.2 Unpacking steps

SHENZHEN CENTER POWER TECH CO., LTD
Address: Rooms 9-12, 7F, Block B, Building 7, Zone 2, Shenzhen Bay Technological and
Ecological Park, Nanshan District, Shenzhen, China
Tel: 0755-66851118 Fax: 0755-66850678 Email: sales@vision-batt.com
Green Our Earth Power Your Vision
5
10.2 Ground connection ....................................................................................................................... 57
10.3 Module installation ....................................................................................................................... 58
10.4 GBMS installation ........................................................................................................................ 61
10.5 Fuse installation ............................................................................................................................ 63
10.6 Interconnection inside the cabinet ................................................................................................ 66
10.6.1 Module connection.............................................................................................................. 66
10.6.2 Tie position ......................................................................................................................... 71
10.6.3 Module communication cable connection .......................................................................... 72
10.6.4 Power cable routing diagram .............................................................................................. 74
10.6.5 GBMS 24V power connection ............................................................................................ 76
10.6.6 CBMS parallel communication connect ............................................................................. 79
10.6.7 AC power connection ......................................................................................................... 82
10.6.8 Set the dial switch ............................................................................................................... 84
10.6.9 CAN/RS485 with UPS ........................................................................................................ 88
10.6.10 Dry contact connection ..................................................................................................... 89
10.6.11 GBMS DIP switch setting ................................................................................................. 90
10.7 UPS Parameter Setting ................................................................................................................. 93
11 Running Test ............................................................................................................... 93
11.1 Starting up examination ................................................................................................................ 93
11.1.1 START-UP CHECKLIST .................................................................................................. 93
11.1.2 Starting up examination ...................................................................................................... 95
11.1.3 SOC validation and calibration ........................................................................................... 95
11.1.4 Startup steps ........................................................................................................................ 96
11.2 Troubleshooting .......................................................................................................................... 104
11.2.1 LED display fault .............................................................................................................. 104
11.2.2 Troubleshooting ................................................................................................................ 104