VT5500 INSTALLATION GUIDE
8
Pre-Installation Checks:
t +44 (0) 1246 225 745 | e orders@visiontrack.com | w visiontrack.com
Validate that the vehicle presented matches the vehicle details on the VisionTrack Service
Portal.
Take note of and document any damage to where the camera(s) will be fitted, e.g.
windscreen and around the number plate.
Follow the pre-installation checks as outlined in the VisionTrack Service Portal.
All vehicle defects must be highlighted to the policy holder and documented in the Portal.
Write down the following (needed for commissioning and job debrief):
• The 10 character DRID number (marked S/N on a white label)
• The 15 character Serial Number (on the white label with the bar code)
• The registration of the vehicle
Make sure the vehicle is parked on flat and level ground.
Please follow these checks before installation is started.
!
1
2
3
4
5
6
To Next Page
Loading...
