Frequency ranges table 1-5 – 1-6
Front Panel Display status field
3-3, 3-12 & 3-15
front panel LED interpreting 3-12 fuse
ratings 2-5
G
grounding the unit 2-4
H
Help screen (Status tab) 3-2
I
Identification screen (Setup tab) 3-6
Identification screen (Status tab) 3-2
IF input
alarm 3-15 setup
field 3-6
IMC BUS connector A-1
Indication alarm severity 3-13
installing 2-1
Invert Spectrum
setup field 3-8, 3-9
status field 3-3, 3-4
IP Address
setup field 3-6
status field 3-2
L
Latch alarm condition 3-13
LEDs, front panel 3-12
M
maximum permissible exposure, see
MPE 2-2
Measured RSL status field 3-5
Modulation 1-1, 2-3, A-4
setup field 3-7, 3-9, 3-10
status field 3-3, 3-4
Modulator screen (Setup tab) 3-7
moisture warning 2-4
Monitor Demod screen (Status) 3-4
Monitor Mod screen (Status tab) 3-3
Monitor Radio screen (Status tab) 3-6
monitoring status 3-2
mounting the indoor unit 1-3, 2-4, 2-6
MPE, calculating 2-2
O
ODU 1-3 – 1-5
antennas 1-8, A-3
ODU alarm 3-15
ODU screen (Setup tab) 3-9
ODU screen (Status tab) 3-5
ODU, installing 1-5, 1-9
OpMode
setup field 3-9
status field 3-5
P
Panel
front 3-3, 3-12, 3-13, 3-15
rear 1-8, 2-2, 2-5, 3-1, A-1
Password setup field 3-11
PC minimum requirements 3-1
PC setup 3-1
Percent Utilization status field 3-3, 3-4 power
alarm 3-15
density 2-3
hazard 2-2
specifications A-1, A-3
PRBS
setup field 3-8 status
field 3-3, 3-4
Protected System Configuration 3-16
pseudo random bit sequence, see PRBS 3-8
R
Radio screen (Setup tab) 3-6
rear panel 1-8
Receive Signal Level Indicator 1-10
Remote Mount Kit (RMK) 1-10
reporting damage 2-1
RF
power hazard 2-2
RF Band setup field 3-10
RF Band status field 3-5
RF performance table 1-5
RJ-45 connector 1-8, A-1, A-2
routing cables 2-5
RSL, alarms 3-15
RX Frequency setup
field 3-9 status
field 3-5
RX PLL alarm 3-15
Index-2
DXL8000 User and Technical Manual
To Next Page
Loading...
General