Visonic NEXT K9-85 PG2 - Video Verification Setup; Local Diagnostics Test Procedure

D-302893 NEXT CAM PG2, NEXT CAM K9-85 PG2 Installation Instructions 3
Caution!
Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to manufacturer's instructions.
7
6
Figure 3b. Final Closure
6. Align the cover with the base.
7. Secure with screw.
2.3. Enrollment
Refer to the PowerMaster panel's Installer Guide and follow the procedure under the "02:ZONES/DEVICES" option of the Installer Menu.
A general description of the procedure is provided in the following flow chart.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Enter the Installer menu
and select
“02:ZONES/DEVICES”
Select "ADD NEW
DEVICE" Option
See Note [1]
Enroll the device or Enter
the device ID
Select the desired Zone
Number
Configure Location,
Zone Type &
Chime Parameters
Configure
the
Detector





 means scroll and select
See Note
[2]
Notes:
[1] If the detector is already enrolled you can configure the detector parameters via the “Modify Devices” option – see Step 2.
[2] Select the "Device Settings" option and refer to section 2.4 to configure the detector parameters.
2.4. Configuring the Detector Parameters
Enter the menu and follow the configuration instructions for the Next CAM PG2 / Next CAM K9-85 PG2 PIR detector as
described in the following table.
Option
Configuration Instructions
Here you determine whether or not the alarm LED indication will be activated.
Optional settings: LED ON (default) and LED OFF.
Here you determine whether an alarm will be activated upon continued motion (low sensitivity) or upon a single
alarm event (high sensitivity)..
Optional settings: LOW sensitive (default) and HIGH sensitive.
Here you determine whether or not to set the activity time during disarm.
Optional settings: NOT Active (default), YES – no delay, YES + 5s delay, YES + 15s delay, YES + 30s delay,
YES + 1m delay, YES + 2m delay, YES + 5m delay, YES + 10m delay, YES + 20m delay and YES + 60m delay.
Note: Not applicable in this version. Do not change this setting!
Here you determine whether or not to report power failure and restore.
Optional settings: NOT connected (default) and Connected to AC.
Here you determine whether the image will be in black & white or color.
Optional settings: Black & White (default) and Color.
Image Color
AC POWER Connect
DISARM Activity
Event Counter
Alarm LED
DEVICE SETTINGS
Z10.DEV SETTINGS
Z10.SET CHIME
Z10.ZONE TYPE
Z10.LOCATION
ID No. 140-XXXX
Z10:Motion Camra
ENTR ID:XXX-XXXX
ENROLL NOW or
MODIFY DEVICES
ADD NEW DEVICES
02.ZONES/DEVICES