VITO 30 - Filtration Process; Requirements and Operation Notes; Starting and Finishing Filtration; Safety Functions

1. Aer the cycle me is displayed wait for the green LED (2) to ash (VITO 80 will beep addionally)
2. Set the beeper status using the push buon (3)
3. The indicators show the selected status:
Red LED (1) = beeper o
Green LED (2) = half volume
Red LED + green LED = full volume (1) + (2)
Pull out the power cord (8).
The new sengs are now saved.
8. Filtraon process
8.1 Requirements
VITO 30 / 50 / 80
• Insert parcle lter into the pump-lter unit (9) (See chapter 11 Parcle lter change.)
• Latch lter-lid
• Put control unit (6) on pump-lter unit (9)
• Tighten the star handles (5).
8.2 Operaon notes
• BEFORE START WORKING WITH VITO YOU MUST TURN OFF THE FRYER .
• Filtraon cycle can be stopped at any me by pressing push buon (3).
• Do NOT move VITO while ltraon is in progress!
• Only use VITO in a straight posion!
• The Power indicator (red LED) (1) and Filtraon indicator (green LED) (2) are lit during
ltraon process.
8.3 Starng the ltraon process
1. Turn o the fryer.
2. Take VITO out of the drip pan (4)
3. Make sure that the parcle lter is in the pump lter unit (9)
4. Put VITO into the fryer.
5. Ensure a secure standing (for holding brackets see chapter 12 Accessories)
6. Check the frying oil level
(The oil level must be between the MIN and MAX marking of the pump-lter unit (9)!)
7. Plug in VITO:
Power indicator (red LED) (1) is acve
Cooling fan is running (VITO50 / VITO 80)
8. Press push buon (3)
9. Filtraon indicator (green LED) (2) is lit during the ltraon.
8.4 Finish the process prematurely
1. Press push buon (3)
Filtraon indicator (green LED) (2) is o
2. Pull the power cord (8): VITO 30
Keep VITO 50 / VITO 80 plugged in!
3. Li VITO, let oil ow back in the fryer
4. Place VITO in the drip pan (4)
9. Safety funcons
9.1 Tilt and vibraon protecon (VITO 80 only)
If VITO 80 is lted more than 15°, topples over or vibrates too strong because of bad placement or
mechanical defect, the machine will switch o. Both indicators start ashing and a repeang beep will
be heard.
9.2 Acousc signal (VITO 80 only)
At the end of each cycle VITO 80 beeps for 5 seconds. VITO 80 will also beep if any error occurs.
9.3 Temperature control
If the temperature of the electrics is exceeded, VITO stops the ltraon.
The power indicator (red LED) (1) starts to ash and VITO 80 starts to beep connuous.
Page 5