VITO must be taken out of the fryer to conrm the error by pressing the push buon (3)
The power indicator (red LED) (1) will connue to ash unl VITO is cooled down.
Leave VITO 50 & VITO 80 plugged in. VITO is operaonal again aer approx. 15 min.
It takes up to 2.5 hours if VITO is unplugged.
If VITO takes too long to cool down aer a temperature based shutdown, the ambient temperature might
be too high or VITO was le in the fryer. VITO 80 will connue to beep every 40 seconds. Take VITO to a cool
place and plug it back in to allow the cooling fan to work.
Do NOT put VITO into a cold-storage room! Condensaon can destroy the electrics.
9.4 Memory
VITO records the operang mes and usage values. These values can be readout using the VITO Data Reader.
(see chapter 12 Accessories)
10. Care and servicing
10.1 Notes
• Clean pump-lter unit (9) at every parcle lter change
• Clean VITO only if cooled down
• Do NOT use abrasives
• Do NOT use wire brushes or similar tools
10.2 Cleaning preparaon
1. Make sure VITO is cooled down
2. Unfasten star handles (5) on both sides
3. Remove control unit (6) from pump-lter unit (9)
4. Open pump-lter unit (9)
5. Dispose parcle lter
6. Manual or machine cleaning
10.3 Manual cleaning
1. Clean control unit (6) only with damp cloth!
2. DON’T put VITO under running water! This can destroy the electrics!
3. If strong dirt then deep clean (boil-out) / Clean the pump-lter unit (9) with soap sud.
4. Dry VITO with a towel.
10.4 Machine cleaning
1. Clean control unit (6) only with a
damp cloth! Do NOT put the electrical
unit (6) into a dishwasher!
This will destroy the electrics
2. Put pump-lter unit (9) and the drip pan (4)
into the dishwasher. Start the cleaning program.
11. Parcle lter change
Change the parcle lter only if necessary. The me of change is based on usage of VITO and the
degree of polluon of the frying oil.
Pay aenon to the cleaning eciency and the spill of oil coming out of the pump-lter unit. (9)
Change the parcle lter only at a low ltraon performance.
Normal ow Low ow