Vitrek 944i - System Configuration Options

To change the Test Name, select the "change" option in the above menu. When the "ENTER STEP NO." prompt appears enter
00 and press enter. Then use the cursor arrows to enter the new test name.
........................................................................................
Printing Test Reports
Before printing, select a compatible line termination via the front panel menu key. The CR + LF option is compatible with most
modern printers. When an automatic test is successfully completed, the following menu selection will be displayed:
TEST PASSED
QUIT PRINT RETEST
If your 944i has the optional IF-4 remote interface package, then it is supplied with a built-in parallel port. For information on
printer port configuration refer to section 6 - Remote Operation, Parallel Port. To obtain a listing of the test results, connect a PC
compatible parallel printer to the 944i rear panel parallel port and press enter.
ENTER DUT S/N
_ _ _ _ _ _ _ _ _ _ _
Numeric entry can be done using the number keys. Alpha characters may be entered using the up down cursor arrows. Once the
DUT serial number has been entered, press the enter key and the printout will commence.
To repeat the test on the existing or new device under test, select the retest option and press enter. To exit the test mode, select the
quit option and press enter.
When any step in an automatic test is failed, the following typical menu will be displayed:
STEP FAILED- MAX CURRENT
QUIT RETRY CONTIN
In this menu the continue option has been added to allow for the completion of the test. When the test is terminated via one of the
above options, the "test passed" or "test failed" menu provides the print option
.
.........................................................................................
Aborting a Test
If at any time the user desires to abort a test, press the High Voltage Disable / Stop key. The following menu will be displayed:
TEST FAILED-ABORTED
QUIT PRINT RETEST
Select the desired option and press enter.
.........................................................................................