Vivint Element CT200 Operation Guide
Product Overview
Z-Wave and Thermostat Programs
The Thermostat must be connected to a Z-Wave network in order to
operate. Use your Z-Wave application to adjust the heating and cool-
ing programs that the Thermostat uses to run your system. You can
temporarily override target temperatures and change system modes
from the thermostat, but you must use the Z-Wave application to
make permanent changes to programs.
Compressor Protection
The Thermostat has a minimum cycle time of four (4) minutes to
protect your compressor from excessive wear from responding to
thermostat changes. The Home screen shows an hour glass and the
message “Please Wait”. The compressor will not come on until the
four-minute delay is over.
35
To Next Page
Loading...
