6. ADD NEW DEVICE
The ‘Add Device’ instruction screen then appears.
1) MAKE SURE YOUR CAMERA’S LED LIGHT IS BLINKING RED
Plug in your camera and wait a moment.
When the red LED light is blinking, tap Continue.
NOTE: The camera’s Wi-Fi can only be found when the camera’s LED indicator light is
red and is flashing. If you do not see this, then the camera will need to be reset. Please
follow these steps:
TO RESET YOUR CAMERA:
- Use the Setup tool (supplied) or a small pin to push and hold the ‘Reset/Set’ button
(hole) found on the back of the camera.
- Release the pin once you hear the camera emit ‘Reset Success’.
- Wait a few moments until the red LED light starts blinking, then tap Continue.
2) CONFIGURE NETWORK
The ‘Configure Network’ screen appears.
The name of the Wi-Fi network that your phone is connected to automatically appears.
Enter the Wi-Fi password and then tap Continue.
3) CONNECTING
The ‘Connecting’ screen appears displaying the connection progress. Please wait for the
indication that the camera has successfully been found and connected.
NOTE: The camera will emit the following once connected: ‘Wi-Fi Connect Success.
Internet Connected. Welcome using Cloud Camera’.
4) ADD CAMERA NAME AND LOCATION
The ‘Add to Account’ screen then appears displaying the camera image along with the
model name and UID number.
Enter the following details for your IP Camera:
Set Name: Enter a name for your camera.
Set Room: Tap to view the list of room names and select the appropriate room.
After setting your camera name and room, tap Done.
To Next Page
Loading...
