To Next PageTo Next PageHow to fix a blurred image on Vivitek D8?
If the image on your Vivitek Projector is blurred, adjust the Focus on the projector. You can also press the Auto button on the remote control or projector. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range and check that the projector lens is clean.
What to do if Vivitek D8 Projector remote control not working?
If your Vivitek Projector does not respond to the remote control, try the following: 1. Direct the remote control towards remote sensor on the projector. 2. Ensure the path between remote and sensor is not obstructed. 3. Turn off any fluorescent lights in the room. 4. Check the battery polarity. 5. Replace the batteries. 6. Turn off other Infrared-enabled devices in the vicinity. 7. Have the remote control serviced.
What to do if there is no light from Vivitek D8?
If there is no light from your Vivitek projector, check that the power cable is securely connected and ensure the power source is good by testing with another electrical device. Try restarting the projector in the correct order and check that the Power LED is green. If you have replaced the lamp recently, try resetting the lamp connections. Consider replacing the lamp module or putting the old lamp back in the projector and having the projector serviced.
How to fix no image on Vivitek Projector?
If no image appears on the screen of your Vivitek Projector, verify the settings on your notebook or desktop PC. Also, try turning off all equipment and powering up again in the correct order.
How to flip the image on a Vivitek Projector?
To flip the image on your Vivitek Projector, check the Projection setting on the Installation I menu of the OSD.
How to correct a trapezoid image on a Vivitek Projector?
To correct a trapezoid image (wider at the top or bottom) on your Vivitek Projector, position the projector so it is as perpendicular to the screen as possible. You can also use the Keystone button on the remote control or projector to correct the problem.
How to fix a Vivitek Projector when no image appears on the screen?
If no image appears on the screen when using your Vivitek Projector, verify the settings on your notebook or desktop PC. If that doesn't work, turn off all equipment and power up again in the correct order.
Why does the lamp go off on my Vivitek D8 Projector?
If the lamp of your Vivitek Projector goes off, it might be due to power surges. Try re-plugging the power cord. When the Ready LED is on, press the power button. You may also need to replace the lamp module or put the old lamp back in the projector and have the projector serviced.
General| Projection Technology | DLP |
|---|---|
| Lamp Life | 10, 000 hours (depending on mode) |
| Inputs | HDMI, VGA, Composite Video, Audio In |
| Output Connectors | Audio Out, VGA Out |
| Power Consumption | <0.5W (Standby) |
