Vivotek IP8335H - Page 77

VIVOTEK
User's Manual - 77
You can click Preview to fine-tune the image, or click Restore to recall the original settings without
incorporating the changes� When completed with the settings on this page, click Save to enable the
settings�
If you want to congure another sensor setting for day/night/schedule mode, please click Prole to open
the Prole settings page as shown below.
Please follow the steps below to setup a prole:
1� Check Enable and apply this prole�
2� Select one of the applicable modes: Day mode, Night mode, or Schedule mode� Please manually
enter a range of time through which you want the Schedule mode to apply�
3. Congure Exposure control settings in the folowing columns� Please refer to the previous page for
detailed information�
4� Click Save to enable the setting and click Close to exit the page�
2011/03/13 17:08:56