Pressing the Reset button for longer than 10 seconds will restore the factory
defaults.
Initial Configuration - via a Local Console
A local console requires the following:
1. A monitor is connected via an HDMI cable.
2. A mouse and/or a keyboard are connected to the system.
3. It is presumed that the system has not been configured yet. The Installation
wizard only appears for an unconfigured machine or one that was restored
to its default.
Follow the onscreen messages to complete the initial configuration:
1. When started for the first time, the system will prompt for the forceful
configuration of a password. This ensures security from malicious network
attack.
Theapplicablealpha‐numericcharactersare
[0‐9][a‐z][A‐Z][!][$][%][‐][.][@][^][_][~],withamax.lengthof64characters.
To Next Page
Loading...
Need help?
General
