Initial Configuration - Wireless Connection (ND8212W)
1. Press the WPS button on wireless camera for 3 to 5 seconds. Refer to
VIVOTEK cameras’ Installation Guide for wireless connection details.
2. Press the WPS button on the NVR for less than 10 seconds. Wait for the
system status LED to change to green.
3. Open the system
Settings
>
Camera Management
page. When
successfully connected, the wireless camera will be listed. If the camera is
accessed for the first time, you should enter a new password to access the
camera.
To Next Page
Loading...
Need help?
General
