Initial Configuration - via a Web Console (Optional)
IMPORTANT:
If you already configured the system using an Ethernet web console, please
skip the Auto Setup steps when you connect the HDMI cable.
You may
accidentally format your storage volumes!
1. Connect the power cord to start the NVR. Wait for the system status LED to
light green.
2. From a management computer, download and execute the
Shepherd
utility
software. Follow the onscreen instructions to complete the installation.
3. Start the Shepherd utility. The Shepherd utility will discover the NVR located
in the same subnet.
4. Double-click on the ND8312 or ND8212W entry to start a web session with
the NVR system.
To Next Page
Loading...
Need help?
General
