Vivotek PD8136 User Manual

VIVOTEK
User's Manual - 7
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button for a while to restore. Note that all settings
will be restored to factory default.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding
standard SD cards.
LED Denitions
Item LED Status Description
1 Steady Red Power on and system booting
Red LED off Power off
2 Steady Red + blinking Green every 1 sec. (Green LED on
for 1 sec and off for another)
Network heartbeat
Steady Red + Green LED off Network disconnected
3 Blinking Red every 0.15 sec. + Blinking Green every 1 sec.
(Red LED on for 0.15 sec. and Green LED on for 1 sec. and
off for another)
Upgrading rmware
4 Blinking Red every 0.15 sec. + blinking Green every 0.15
sec.
Restoring defaults

Vivotek PD8136 Specifications

General

Brand	Vivotek
Model	PD8136
Category	Security Camera
Language	English