Vixel 9000 Series Installation & Configuration Guide CHAPTER 3 Managing the Switch
15
A quick list of frequent configuration tasks and their locations is shown here. Once
you reach the location, you may need to click Change Settings and/or other links or
buttons before configuration parameters are available for changing.
Configuration Task Location in Web Manager
Change the Port Link Speed Ports> Advanced
Change device identification System> System
Upgrade firmware System> Firmware
(click Load New Image)
Set the Ethernet mode System> System
Configure zoning Zoning
Choose a Switch Address Mode System> Mode
Configure traps System> Traps
Define event log & LED severities System> Events
Reset switch
Note: The Reset button on the Configure
Port Zoning and Stealth-3 web pages
clears changes made on that page and re-
displays your saved settings. It does not
reset the switch or ports.
Home (click Reset Switch)
Change password (for access to Web
Manager & CLI)
Note: For security, passwords should be
changed only through a serial connection
to the switch. Because the password-
changing process is unencrypted, using
Ethernet or other types of connections to
change passwords exposes the old and
new passwords to possible security
breach.
System> System (click Change
Admin Password, at bottom of
page)
To Next Page
Loading...
General