VIZIO VL420M/VL470M User Manual
10
www.VIZIO.com
Stand Neck
(already attached
to TV)
Stand Base
Bottom view
Vizio TV
(back)
TV Setup and Stand Assembly (VL420M)
Note: We strongly recommend that two people perform the setup and assembly due to the weight and
size of the TV.
To unpack the TV and stand base:
1. Remove the remote control, batteries, and power cord from the foam end caps.
2. Remove the two top foam end caps.
3. Remove the stand base under foam end cap.
4. Remove the TV from the box and lay it face down on a clean, flat surface.
Note: Make sure that the surface is free of debris to prevent the TV screen from getting scratched.
To attach the TV stand base:
1. Push the stand base onto the stand neck (already connected to TV).
2. On the bottom of the base, insert the thumb screw and tighten. Move the TV into an upright
position.
To Next Page
Loading...
Need help?
General
