2 Regulatory information
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly ap-
proved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
WEEE DIRECTIVE
If the time arises to throw away your product, please recycle
all the components possible.
This symbol indicates that when the end-user wishes to dis-
card this product, it must be sent to separate
collection facilities for recovery and recycling.
By separating this product from other house-
hold-type waste, the volume of waste sent to
incinerators or land-fills will be reduced and
natural resources will thus be conserved.
The Waste Electrical and Electronic Equipment Directive
(WEEE Directive) aims to minimise the impact of electrical
and electronic goods on the environment. Void comply with
the Directive 2002/96/EC and 2003/108/EC of the European
Parliament on waste electrical finance the cost of treatment
and recovery of electronic equipment (WEEE) in order to
reduce the amount of WEEE that is being disposed of in
land-fill site.
All of our products are marked with the WEEE symbol; this
indicates that this product must NOT be disposed of with
other waste. Instead it is the user’s responsibility to dispose
of their waste electrical and electronic equipment by hand-
ing it over to an approved reprocessor, or by returning it to
Void for reprocessing. For more information about where
you can send your waste equipment for recycling, please
contact Void or one of your local distributors.
EC DECLARATION OF CONFORMITY
Manufacturer:
Void Acoustics Research Ltd
Unit 15, Dawkins Road Ind Est.,
Poole,
Dorset, BH15 4JY,
United Kingdom
We declare that under our sole responsibility the products:
Model Names: Bias V3
Bias V9
Intended use: Professional Audio Amplifier
Are in conformity with the provisions of the following EC
Directives, including all amendments, and with national leg-
islation implementing these directives:
• 2006/95/EC Low Voltage Directive
• 2004/108/EC Electromagnetic Compatibility Directive
• 2002/95/CE RoHs Directive
The following armonized standards are applied:
• EN 55103-1:2009 /A1:2012
• EN 55014-1:2006 /A1:2009 /A2:2011
• EN 55022:2010 /AC:2011
• EN 61000-3-2:2006 /A1:2009 /A2: 2009
• EN 61000-3-3:2013
• EN 61000-3-11:2000
• EN 61000-3-12:2011
• EN 55103-2:2009 /IS:2012
• EN 61000-4-2:2009
• EN 61000-4-3:2006 /A1:2008 /IS1:2009 /A2:2010
• EN 61000-4-4:2012
• EN 61000-4-5:2006
• EN 61000-4-6:2014
• EN 61000-4-11:2004
• EN 60065:2002 /A1:2006 /A11:2008 /A2:2010 /A12:2011
For compliance questions only: info@voidacoustics.com
To Next Page
Loading...
Need help?
General
