Volt Time Source 2 Installation Guide - alternative entry
Installation procedures
Source 2 has two types of installation procedures which should
be determined before starting the installation.
● Installing the product via the entry on the rear
(maximum cable-cross section is 10mm2).
● Installing the product with the AC Mains Connector
set (maximum cable-cross section is 6mm2).
To install the product using the entry on the rear, follow this
document.
For installations using the AC Mains Connector, scan the
following QR code to find Installation Guide:
Or go to https://volttime.com/manuals to download the
manual for wiring through the back.
To Next Page
Loading...