Controls
1 Hazard lights
2 Rheostat for regulating the
instrument lighting
3 Indicator lamp, front fog lights
4 Light switch (spring-loaded)
Pull out: Rear fog lights on/off
Press: Front fog lights on/off
5 Lighting switched off or automatic
dipped lights
6 Parking lights
7 Main and dipped beam
8 Extra headlamps (option)
9 Indicator light, rear fog lights
Hazard warning light
When the warning light button is
pressed, all the warning lights will come
on. The warning lights can be used even
when the main switch and the ignition
have been turned off.
WARNING
Always use the warning lights if the bus
has been stopped in such a way that it can
cause danger for other road users.
Rear-view mirrors
Both rear-view mirrors are adjusted
using the same knob. The knob can be
turned to one of the two positions,
adjustment of the right or left mirror. The
selected mirror is adjusted by moving the
knob in the appropriate direction.
NOTE
Rear view mirrors should be adjusted
before starting to drive.
Cruise control
Cruise control is used to operate the bus
at a constant lowest speed within the
interval 30–130 km/h.
Once the bus has reached the desired
speed, activate cruise control by moving
the sliding button (2) to ON and then
pressing + or - on the SET button (1). To
increase or decrease the speed, press +
or - again.
NOTE
The brake and clutch pedals must be fully
released.
If the speed is temporarily increased with
the accelerator pedal, the vehicle will
return to the set speed after releasing
the accelerator pedal.
Disconnect
Disconnect the cruise control by pushing
the switch (2) to the OFF position or by
pressing the brake or clutch pedal.
To return to the previously set speed
after disconnecting the cruise control,
04
Instruments and controls
24
To Next Page
Loading...
