Switch to the right (B) in X1 mode: accessory flow
through pipe on right side of boom
NOTE!
While turning ON the ignition switch or lowering the
arm rest, a neutral detection is performed for the
roller switch on the right control lever. The offset
control lamp blinks when the roller is not in its
neutral position and the proportional function (X1 or
boom offset) is disabled.
The function becomes active (operational) once the
roller comes back to its neutral position.
Hydraulic oil flow, changing maximum setting
for X1 and X3
There is a possibility to set the maximum hydraulic
oil flow used for the first auxiliary (X1) and for X3
(only for machines equipped with switches 7 and 9
and on 8 with a proportional roll switch).
1 Select the boom offset mode. The control lamp
in the instrument panel lights up when the offset
boom is activated.
NOTICE
Boom offset must be selected before changing the
maximum hydraulic oil flow setting. If attachment
movement is selected this can result in an
unexpected movement of the optional equipment.
To Next Page
Loading...
