Specifications
118 Cabin
Cabin
Vibration and sound information
Hand-arm vibrations
Emission of hand-arm vibration during real operating conditions at its intended use is less than 2.5 m/s
2
RMS (root
mean square) acceleration according to ISO 8041.
Whole-body vibrations
Emission of Whole-Body Vibration during real operating conditions at its intended use is according to the table
below.
The following vibration directions are defined:
x = fore and aft
y = lateral
z = vertical
The whole-body vibration values given above have been taken from ISO/CEN Technical Report.
NOTE! These whole-body vibration emission values were determined at particular operating and terrain
conditions and is therefore not representative for all the various conditions in accordance with the inten-
ded use of the machine and should not alone be used to determine the whole-body vibration exposure to
the operator using the machine. For this purpose the information in ISO/CEN Technical Report is recom-
mended.
To ensure that the whole-body vibration emission during machine use is kept to a minimum, see page 48.
Sound information
Typical operating conditions Vibration emission value
1.4*a
w,eqx
(m/s² RMS)
Vibration emission value
1.4*a
w,eqy
(m/s² RMS)
Vibration emission value
a
w,eqz
(m/s² RMS)
Excavating 0.33 0.21 0.19
Hydraulic breaker app. 0.49 0.28 0.36
Transfer movement 0.45 0.39 0.62
EC35
Cabin
EC35
Canopy
EC45
Cabin
EC45
Canopy
Sound pressure level (LpA) at operator posi-
tion
(Measurement according to ISO 6396)
78 LpA dB(A) 80 LpA dB(A) 78 LpA dB(A) 80 LpA dB(A)
Sound power level (LwA) around the machine
(Measurement according to 2000/14/EC with
applicable appendices and measuring method
according to ISO 6395)
96 LwA dB(A) 96 LwA dB(A) 96 LwA dB(A) 96 LwA dB(A)
To Next Page
Loading...
